Screw-in extractor tab MK4 / M16
€4.00*
Prices incl. 19% VAT. plus Shipping costs
Delivery time: 1-3 working days **
More than 10 pieces available (online and in specialist shops)
Intended use
Tools with a Morse taper can be removed from the tool holder of machines with the aid of drive-out wedges.
Technical data
| Length of tightening thread [mm]: | 17 |
|---|---|
| Morse taper: | MK4 |
| Tightening thread: | M16 |
| Total length [mm]: | 42 |
| Total length [mm]: | 42 |
For MK4 cone
Can be screwed in via M16 thread
Made from burnished steel
Description of the
This screw-in drift pad is made of burnished steel. It can be screwed into tools with an MK4 cone using the M16 tightening thread.
Scope of delivery
- 1 x extractor tab for MK4
More about the brand and products from
This screw-in drift pad is made of burnished steel. It can be screwed into tools with an MK4 cone using the M16 tightening thread.
This screw-in drift pad is made of burnished steel. It can be screwed into tools with an MK3 cone using the M12 tightening thread.
This screw-in drift pad is made of burnished steel. It can be screwed into tools with an MK2 cone using the M10 tightening thread.
This screw-in drift pad is made of burnished steel. It can be screwed into tools with an MK1 cone using the M6 tightening thread.
€4.00*
Content: 1 pcs
€3.50*
Content: 1 pcs
€3.00*
Content: 1 pcs
€2.50*
Content: 1 pcs
23 February 2025 14:53
Der Kegelschaft kann damit in der Säulenbohrmaschine verwendet werden, das Preis-Leistungs-Verhältnis ist top
Einwandfrei, macht das was er soll und wird dann eingeschraubt in den MK-Kegel, wenn er in der Säulenbohrmaschine verwendet wird, bei Nutzung an der Drehmaschine wird er wieder abgeschraubt. Das Preis-Leistungs-Verhältnis ist top und gerade für Heimwerker wichtig, arbeiten wie ein Profi und Paulimot hat dazu die Ware.