Minimum quantity lubrication
€29.50*
Prices incl. 19% VAT. plus Shipping costs
Delivery time: 1-3 working days **
More than 10 pieces available (online and in specialist shops)
Intended use
Minimum quantity lubrication (MQL) according to the Venturi principle is a special lubrication method in which only a very small amount of lubricant is used to reduce wear and friction when machining workpieces on machine tools. In contrast to conventional lubrication systems, in which a large quantity of lubricant is used, only a minimal lubricating film is used in minimum quantity lubrication. The lubricant is applied in the form of an aerosol, emulsion or oil mist directly to the cutting edge of the tool or in the machining area of the workpiece.
Technical data
| Length of segment hose incl. spray nozzle [mm]: | 335 |
|---|---|
| Material segment hose: | Plastic |
| Material spray nozzle: | brass |
| Mounting block dimensions [mm]: | 30 x 37.5 x 19 |
| Suction hose length [mm]: | 1.330 |
| Valve block material: | Aluminium |
| Ø air hose connection [mm]: | 8 |
| Ø mounting holes valve block [mm]: | 5,7 |
For use on all machine tools
Creates a minimal lubricating film
Saves lubricant
Reduces wear and friction
Most precise dosing possible
Description of the
This minimum quantity lubrication system consists of a brass valve block with adjusting screw, a segmented hose with adjustable spray nozzle, a suction hose with suction filter and a compressed air connection for air hoses. There are two holes on the valve block which allow it to be permanently mounted on the machine.
Scope of delivery
- 1 x minimum quantity lubrication
Videos
More about the brand and products fromÂ
1 February 2026 07:11
wenn man weiß wie : perfekt
Die ersten Versuche mit der MMS und dem empfohlenen K8 Flüsterkompressor von Paulimot waren ernüchternd - nach kurzer Zeit kein Flüssigkeitstransport mehr. Das was man unbedingt wissen sollte: den Ansaugvorgang kann man mit Aufdrehen und danach wieder Zudrehen der Venturi-Düse (das Messingteil vorne am Gelenkschlauch) "starten". Was man bei Verwendung des K8 Kompessors beachten sollte: - den K8 auf 4 bar voreinstellen - die Oberfläche der Schmierflüssigkeit darf zumindest beim K8 maximal 20cm tiefer als die Venturi-Düse stehen - das Regelventil der MMS so einstellen (zudrehen) das der K8 noch seinen Betriebsdruck halten kann
21 July 2025 11:48
Die MMS hat mir beim drehen und
Die MMS hat mir beim drehen und fräsen von Alu-Knetlegierung geholfen., Keine Aufbauschneide und dementsprechend gute Oberflächen. Die Schmiereinrichtung läuft soweit wie gewünscht, wenn man den Luftstrom über ein externes Absperrventil regelt. Bei meiner MS ist das Nadelventil relativ wirkungslos. Völliges Absperren ist bei 4 bar Luftdruck nicht möglich. Ohne diese Manko wären 5 Sterne drin gewesen.
30 January 2025 10:02
Qualität und Preisleistung in Ordnung
Qualität und Preisleistung in Ordnung