HSS broach 4 mm

This broach can be used to cut keyways or keyways with a width of 4 mm.

Broaches are usually used in rack and pinion presses or hydraulic workshop presses.

This broach is made of HSS steel and is slightly conical, the cutting edges thicken in the cutting direction. As a result, the broached keyway becomes slightly deeper with each tooth.

To cut a keyway, the workpiece is placed on the work table of the press and the appropriate guide bush is inserted into the bore of the workpiece. The broach is then inserted into the holder, moistened with sufficient cutting oil and pressed through the workpiece with the press. The shims can be used to make the groove deeper.

This broach can be used to cut keyways or keyways with a width of 2 mm.

Broaches are usually used in rack and pinion presses or hydraulic workshop presses.

This broach is made of HSS steel and is slightly conical, the cutting edges thicken in the cutting direction. As a result, the broached keyway becomes slightly deeper with each tooth.

To cut a keyway, the workpiece is placed on the work table of the press and the appropriate guide bush is inserted into the bore of the workpiece. The broach is then inserted into the holder, moistened with sufficient cutting oil and pressed through the workpiece with the press. The shims can be used to make the groove deeper.

This broach can be used to cut keyways or keyways with a width of 3 mm.

Broaches are usually used in rack and pinion presses or hydraulic workshop presses.

This broach is made of HSS steel and is slightly conical, the cutting edges thicken in the cutting direction. As a result, the broached keyway becomes slightly deeper with each tooth.

To cut a keyway, the workpiece is placed on the work table of the press and the appropriate guide bush is inserted into the bore of the workpiece. The broach is then inserted into the holder, moistened with sufficient cutting oil and pressed through the workpiece with the press. The shims can be used to make the groove deeper.

This broach can be used to cut keyways or keyways with a width of 5 mm.

Broaches are usually used in rack and pinion presses or hydraulic workshop presses.

This broach is made of HSS steel and is slightly conical, the cutting edges thicken in the cutting direction. As a result, the broached keyway becomes slightly deeper with each tooth.

To cut a keyway, the workpiece is placed on the work table of the press and the appropriate guide bush is inserted into the bore of the workpiece. The broach is then inserted into the holder, moistened with sufficient cutting oil and pressed through the workpiece with the press. The shims can be used to make the groove deeper.

This broach can be used to cut keyways or keyways with a width of 6 mm.

Broaches are usually used in rack and pinion presses or hydraulic workshop presses.

This broach is made of HSS steel and is slightly conical, the cutting edges thicken in the cutting direction. As a result, the broached keyway becomes slightly deeper with each tooth.

To cut a keyway, the workpiece is placed on the work table of the press and the appropriate guide bush is inserted into the bore of the workpiece. The broach is then inserted into the holder, moistened with sufficient cutting oil and pressed through the workpiece with the press. The shims can be used to make the groove deeper.

This broach can be used to cut keyways or keyways with a width of 8 mm.

Broaches are usually used in rack and pinion presses or hydraulic workshop presses.

This broach is made of HSS steel and is slightly conical, the cutting edges thicken in the cutting direction. As a result, the broached keyway becomes slightly deeper with each tooth.

To cut a keyway, the workpiece is placed on the work table of the press and the appropriate guide bush is inserted into the bore of the workpiece. The broach is then inserted into the holder, moistened with sufficient cutting oil and pressed through the workpiece with the press. The shims can be used to make the groove deeper.