Mounting flange for ER32 collets Ø 160 mm
Intended use
With a mounting flange for collets, these can also be used on a lathe. In contrast to clamping with three- or four-jaw chucks, clamping with collets ensures that the material is clamped cleanly and gently, and pressure marks are avoided, especially on softer workpieces. As a rule, collet systems have a higher concentricity compared to lathe chucks.
Technical data
| Concentricity deviation max. [mm]: | 0.025 (10 mm) / 0.04 (50 mm) |
|---|---|
| Cylindrical internal fit [mm]: | 130 |
| Diffuser [mm]: | 24 |
| Drill holes: | 3 x M8 |
| Max. revolutions [rpm].: | 1.400 |
| Outer diameter Ø [mm]: | 160 |
| Pitch circle [mm]: | 142 |
| Recording: | Cylindrical holder |
| Total height (incl. union nut) [mm]: | 50 |
| Material: | Steel, hardened and ground |
Made from steel, hardened and ground
For holding ER32 collets
For clean and gentle clamping, even for smaller diameters
Max. concentricity deviation: 0.025 mm for 10 mm overhung / 0.04 mm for 50 mm overhung
Description of the
This mounting flange for ER32 collets is made of hardened steel, the surfaces are ground. The flange can be mounted on lathes with a 160 mm holder with a cylindrical holder instead of a lathe chuck. The clearance is 24 mm.
Procedure for inserting ER collets:
- Insert the groove of the collet at an angle into the eccentric ring of the union nut until it audibly engages.
- Screw the union nut with the inserted collet into the mounting flange.
Scope of delivery
- 1 x mounting flange for ER32 collets Ø 160 mm
- 1 x hook spanner for ER32
More about the brand and products from
