Mounting flange for ER32 collets Ø 80 mm
Intended use
With a mounting flange for collets, these can also be used on a lathe. In contrast to clamping with three- or four-jaw chucks, clamping with collets ensures that the material is clamped cleanly and gently, and pressure marks are avoided, especially on softer workpieces. As a rule, collet systems have a higher concentricity compared to lathe chucks.
Technical data
| Concentricity deviation max. [mm]: | 0.025 (10 mm) / 0.04 (50 mm) |
|---|---|
| Cylindrical internal fit [mm]: | 55 |
| Diffuser [mm]: | 24 |
| Drill holes: | 3 x M6 |
| Max. revolutions [rpm].: | 1.400 |
| Outer diameter Ø [mm]: | 80 |
| Pitch circle [mm]: | 66 |
| Recording: | Cylindrical holder |
| Total height (incl. union nut) [mm]: | 50 |
| Material: | Steel, hardened and ground |
Made from steel, hardened and ground
For holding ER32 collets
For clean and gentle clamping, even for smaller diameters
Concentricity deviation max.: 0.025 mm with 10 mm overhung / 0.04 mm with 50 mm overhung
Description of the
This mounting flange for ER32 collets is made of hardened steel, the surfaces are ground. The flange can be mounted on lathes with an 80 mm cylindrical holder instead of a lathe chuck. The clearance is 24 mm.
Procedure for inserting ER collets:
1. insert the groove of the collet at an angle into the eccentric ring of the union nut until it audibly engages.
2 Screw the union nut with the inserted collet chuck into the mounting flange.
Scope of delivery
- 1 x mounting flange for ER32 collets Ø 80 mm
- 1 x hook spanner for ER32
More about the brand and products from
