Category: Other projects
Die holder with PM5000
Builder: Klaus Zenkert
The project
As no die holder was available for the "Akon holder" for taps in MK3, the missing die holder for the taps was made by the customer.
Tool used
- Lathe PM5000
- Steel holder with prism for "Multifix" system, size A
- Quick-change steel holder set, "Multifix" system, size A
- Turning tool
- Vertex dividing attachment
- Drill chuck
- Milling cutter
- Knurling tool
Procedure
Step 1
Preparation
Firstly, a shaft with a diameter of 60 mm was over-turned to 59 mm.
Step 2
Turn the contour of the holder
The next step was to turn the contour of the holder and drill the inner hole.
Step 3
Drill out the hole
The hole for the MK3 arbor was turned out and the holder was cut off.
Step 4
Turn out the holder
In the next step, the inside diameter for the tap holder (M12) was turned out.
Step 5
Create thread
The five M5 threads for attaching the thread cutting die were created on the dividing head and a spanner width was milled.
Step 6
Knurling the grip surface
Finally, the grip surface was knurled.
Contact details
If you have any further questions about the project, you can contact the builder by e-mail.
Tip
Articles used paulimot
Lathe PM5000 Professional with 400 volt motor and measuring system
Article no:
15000400-M
Gross weight:
660 kg
€4,999.00*
€5,795.00*
Available immediately
paulimot Quick-change steel holder set, suitable for "System Multifix", size A
Article no:
7003
Gross weight:
4,737 kg
€222.00*
Available immediately
paulimot Steel holder with prism suitable for "System Multifix", size A
Article no:
7005
Gross weight:
0,653 kg
€46.00*
Available immediately